Repareer je spullen Gemeenschap Winkel

Neato Botvac 80 Rear Bumper Replacement

Inleiding

This is a prerequisite guide to remove the rear bumper. Most repairs/ replacements will require you to remove the bumper and this guide will help you out.

  1. Neato Botvac 80 Rear Bumper Replacement, Rear Bumper: stap 1, afbeelding 1 van 1

    • Grab the rear bumper with both hands on either side.

    Vertaal

    pull the free bottom corners out a bit to free the catches

    wilfried - Antwoord

  3. Neato Botvac 80 Rear Bumper Replacement: stap 2, afbeelding 1 van 1

    • Pull the left and right sides away from the machine to unclip the bumper. This requires that you bend the plastic a little bit. Unclip one side a little bit and allow the prong to rest on the side of the machine. Then unclip the other side and pull off the bumper parallel to both sides

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Auteur

met 3 andere bijdragers

Brandon Blank

Lid sinds: 02/02/17

675 Reputatie

5 handleidingen geschreven

Medailles: 11

+8 andere badges

Team

USF Tampa, Team 17-5, Blackwell Spring 2017 Lid van USF Tampa, Team 17-5, Blackwell Spring 2017

USFT-BLACKWELL-S17S17G5

3 Leden

12 handleidingen geschreven

Één opmerking

Is the rear bumper a single piece that is both upper and lower part joined?

Sanjukta - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 2

Altijd: 1,434