Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

Repair USB Connector for mouse

Check Vol, Data -, Data +, Ground for sure.

  1. I have old mouse (no have USB) and old flash drive (can't use memory). So, I will use flash drive's USB to replace mouse's connector
    • I have old mouse (no have USB) and old flash drive (can't use memory). So, I will use flash drive's USB to replace mouse's connector

  2. Use soldering iron for take USB from flash drive.
    • Use soldering iron for take USB from flash drive.

  3. Soldering components together. In this case Red=Vol, White=Data -, Green=Data +, Blue=Ground.
    • Soldering components together. In this case Red=Vol, White=Data -, Green=Data +, Blue=Ground.

  4. Test mouse.
    • Test mouse.

  5. If mouse is working, use heat-shrinkable tubing for close component and done.
    • If mouse is working, use heat-shrinkable tubing for close component and done.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

fchitphon

Lid sinds: 14-02-15

181 Reputatie

1 Handleiding geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 12

Afgelopen 30 dagen: 42

Altijd: 2,901