Inleiding

This guide will install the motherboard, which will require removal of the battery and disconnection of the speaker and microphone ribbon cables.

Onderdelen

Geen onderdelen nodig.

  1. Place thumb on the rubber tab on the lower back of the phone.
    • Place thumb on the rubber tab on the lower back of the phone.

    • Push away from the phone to release back panel.

    Voeg opmerking toe

  2. Lift the back panel of the phone to expose battery (not shown here).
    • Lift the back panel of the phone to expose battery (not shown here).

    Voeg opmerking toe

    • Pull the antenna up to reveal two of the six screws.

    Voeg opmerking toe

    • Unscrew all six screws on the back side of the phone using a T-6 bit.

    Voeg opmerking toe

    • Gently separate the front and back sides of the phone, as shown in the picture.

    • Be careful not to break or bend the ribbon cables.

    Voeg opmerking toe

    • Detach the first ribbon cable by unplugging it from the motherboard.

    Voeg opmerking toe

    • Detach the speaker ribbon cable from the motherboard.

    Voeg opmerking toe

    • Remove the motherboard from the front half of the phone by gently shaking it loose. It should come out with little to no trouble.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Ariel

Lid sinds: 11-03-13

16 Reputatie

4 handleidingen geschreven

Team

Clemson, Team 13-6, Benson Spring 2013 Lid van Clemson, Team 13-6, Benson Spring 2013

CLEM-BENSON-S13S13G6

3 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 89