Inleiding
Before continuing make sure you power down your device and work in a clean area. Also wear a static band to prevent damages to your device.
Wat je nodig hebt
-
-
Remove the back cover using the thumb tab located on the bottom of the phone.
-
-
-
Using a T4 Torx driver, remove the eight 4 mm back panel screws.
-
-
-
-
Use your plastic opening tool to disconnect the motherboard/keyboard ribbon cable.
-
-
-
Flip the board over and you will see that the camera is connected by a ribbon cable.
-
Unlock the cable by using a plastic remover tool then pull the camera out.
-
Insert the new camera and re lock the ribbon cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
2 andere personen hebben deze handleiding voltooid.