Repareer je spullen Gemeenschap Winkel

Motorola Buzz ic502 Screen and Speaker Replacement

Inleiding

This guide will show you how to replace the screen and the plastic display assembly along with it.

Wat je nodig hebt

  1. Motorola Buzz ic502 Screen and Speaker Replacement, Battery: stap 1, afbeelding 1 van 3 Motorola Buzz ic502 Screen and Speaker Replacement, Battery: stap 1, afbeelding 2 van 3 Motorola Buzz ic502 Screen and Speaker Replacement, Battery: stap 1, afbeelding 3 van 3

    • First flip the phone over.

    • Then find the back release circled in red.

    Bewerken

  2. Motorola Buzz ic502 Screen and Speaker Replacement: stap 2, afbeelding 1 van 2 Motorola Buzz ic502 Screen and Speaker Replacement: stap 2, afbeelding 2 van 2

    • Carefully remove the back using the release.

    • Lift from the bottom!

    Bewerken

  4. Motorola Buzz ic502 Screen and Speaker Replacement: stap 3, afbeelding 1 van 3 Motorola Buzz ic502 Screen and Speaker Replacement: stap 3, afbeelding 2 van 3 Motorola Buzz ic502 Screen and Speaker Replacement: stap 3, afbeelding 3 van 3

    • Lift the battery from the right side.

    • After the battery has lifted about a 45 degree angle remove from phone.

    Bewerken

  5. Motorola Buzz ic502 Screen and Speaker Replacement, Screen Assembly: stap 4, afbeelding 1 van 3 Motorola Buzz ic502 Screen and Speaker Replacement, Screen Assembly: stap 4, afbeelding 2 van 3 Motorola Buzz ic502 Screen and Speaker Replacement, Screen Assembly: stap 4, afbeelding 3 van 3

    • Remove all six screws

    • The two top screws here

    • The two middle screws here.

    • And the two bottom screws here, they are covered by plastic pieces that first must be removed with the nylon Spudger.

    Bewerken

  6. Motorola Buzz ic502 Screen and Speaker Replacement: stap 5, afbeelding 1 van 3 Motorola Buzz ic502 Screen and Speaker Replacement: stap 5, afbeelding 2 van 3 Motorola Buzz ic502 Screen and Speaker Replacement: stap 5, afbeelding 3 van 3

    • then carefully lift the front off the phone.

    • Marked wire will have to be solderd when re-connecting new screen

    • Speakers are connected to the screen here.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order, soldering wire onto new screen.

Auteur

met 2 andere bijdragers

Austin Quinn

Lid sinds: 10/20/16

401 Reputatie

4 handleidingen geschreven

Medailles: 3

Team

UMass Dartmouth, Team 6-6, Martin Fall 2016 Lid van UMass Dartmouth, Team 6-6, Martin Fall 2016

UMASSD-MARTIN-F16S6G6

3 Leden

5 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 3

Altijd: 88