Ga door naar hoofdinhoud

Inleiding

How to remove the blade for replacement or to service the cutting head in a Mk Diamond Wet Saw MK660 2010.

Gereedschap

Geen gereedschap opgegeven.

  1. Before you begin, make sure to power off and unplug the device from the outlet. If the clear water pump hose is connected, remove it now. Loosen the plastic knob holding the saw's cutting head in place.
    • Before you begin, make sure to power off and unplug the device from the outlet.

    • If the clear water pump hose is connected, remove it now.

    • Loosen the plastic knob holding the saw's cutting head in place.

    • Lower the cutting head while keeping it steady.

  2. Unscrew the knob. Remove it from the cutting head.
    • Unscrew the knob.

    • Remove it from the cutting head.

  3. Loosen the plastic knob holding the blade cover in place. Loosen the plastic knob holding the blade cover in place.
    • Loosen the plastic knob holding the blade cover in place.

  4. Loosen the wing nut on the blade cover pivot shaft. Remove the wing nut and accompanying washer. Remove the wing nut and accompanying washer.
    • Loosen the wing nut on the blade cover pivot shaft.

    • Remove the wing nut and accompanying washer.

  5. Pivot the blade cover up and pull it off the shaft. Pivot the blade cover up and pull it off the shaft.
    • Pivot the blade cover up and pull it off the shaft.

  6. Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade. Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench. Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.
    • Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.

    • Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.

  7. Remove the hex nut. Remove the outer flange.
    • Remove the hex nut.

    • Remove the outer flange.

  8. Remove the cutting blade. The blade can be sharp, so handle with care.
    • Remove the cutting blade.

    • The blade can be sharp, so handle with care.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Carsten Frauenheim

Lid sinds: 10-03-20

50.386 Reputatie

283 handleidingen geschreven

Team

iFixit Lid van iFixit

Community

138 Leden

16.436 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 119