Minolta Dimage Xt LCD Screen Disassembly

Inleiding

If you need to replace the LCD screen of your Minolta Dimage Xt, follow this guide. The LCD screen is held into the camera by the outer casing and an internal bracket. It is one component, so there isn't a way to just replace the LCD screen, without first removing other parts. Once screen is out of the bracket, wires must be removed to completely remove the LCD screen.

Before beginning this guide, be sure to remove the batteries from the camera.

Wat je nodig hebt

Stap 1 Casing

Minolta Dimage Xt LCD Screen Disassembly, Casing: stap 1, afbeelding 1 van 3

Minolta Dimage Xt LCD Screen Disassembly, Casing: stap 1, afbeelding 2 van 3

Minolta Dimage Xt LCD Screen Disassembly, Casing: stap 1, afbeelding 3 van 3

Locate and remove the silver screws on each side of the camera.
Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

Vertaal

Stap 2

Minolta Dimage Xt LCD Screen Disassembly: stap 2, afbeelding 3 van 3

Then, carefully pry apart the front and back outer casing away from the internal components.
Be aware of the ribbon wire that will disconnect when the casing is detached.

Vertaal

Stap 3 LCD Screen

Minolta Dimage Xt LCD Screen Disassembly, LCD Screen: stap 3, afbeelding 1 van 1

The LCD screen has wires connecting it to the rest of the camera. A bracket holds the LCD in place, so there are no screws beyond this point.
The screen also has a ribbon wire connected at the bottom of the screen.

Vertaal

Stap 4

Detach the connector at the bottom from the LCD screen.
Starting from the side or a corner gently slide the spudger underneath the screen.
Press the tip of the spudger down as far is you can and slowly pry the LCD screen away from the bracket.

Vertaal

Stap 5

The screen is not detached. Wires are still connecting the screen to the camera at the bottom corners, but it is removed from the bracket.
Check to make sure the wires are connected, so it will receive proper power supply.
To remove the bracket from the LCD screen, remove two 1.5 mm screws using the Phillips #00 screwdriver.

Vertaal

Conclusie

To install a new LCD screen you will have to reconnect the wires and properly place them in the bracket. Make sure to reattach the ribbon wire before finishing repairs.

Één andere persoon heeft deze handleiding voltooid.