Repareer je spullen Gemeenschap Winkel

Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement

Inleiding

This guide will walk through the steps to replace the forward/reverse shuttle on the Milwaukee M12 2407-20.

Wat je nodig hebt

  1. Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement, Outer Casing: stap 1, afbeelding 1 van 1

    • Remove each of the seven 14mm Pan Hd. T-10 ST screws on one side of the housing assembly using the T10 screwdriver.

    Bewerken

  2. Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement: stap 2, afbeelding 1 van 1

    • Remove metal clip located at the base of the drill, where the battery is to be inserted.

    • You may need to use a spudger if the clip is too difficult to remove with your fingers.

    Bewerken

  4. Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement, Forward/Reverse Shuttle: stap 3, afbeelding 1 van 3 Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement, Forward/Reverse Shuttle: stap 3, afbeelding 2 van 3 Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement, Forward/Reverse Shuttle: stap 3, afbeelding 3 van 3

    • Use both hands to lift and remove the gear case assembly from the shell casing.

    • Set the gear case assembly aside.

    Bewerken

  5. Milwaukee M12 2407-20 Forward/Reverse Shuttle Replacement: stap 4, afbeelding 1 van 1

    • While holding the shell in one hand, pull the end of the broken forward/reverse shuttle out of the casing.

    • Set the broken forward/reverse shuttle aside.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 3

Afgelopen 7 dagen: 8

Afgelopen 30 dagen: 20

Altijd: 1,757