Ga door naar hoofdinhoud

Inleiding

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

  1. Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver. Screw length is 16 mm.
    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

  2. Remove the top of the boat by sliding it backwards and then pulling it off. Remove the top of the boat by sliding it backwards and then pulling it off. Remove the top of the boat by sliding it backwards and then pulling it off.
    • Remove the top of the boat by sliding it backwards and then pulling it off.

  3. iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now

    iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now
  4. Grab the rubber gasket with tweezers and pull it out of the slot. Grab the rubber gasket with tweezers and pull it out of the slot.
    • Grab the rubber gasket with tweezers and pull it out of the slot.

  5. Gently remove the gasket and replace with a new one. Gently remove the gasket and replace with a new one. Gently remove the gasket and replace with a new one.
    • Gently remove the gasket and replace with a new one.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Monica Reece

Lid sinds: 31-08-18

651 Reputatie

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 54