Inleiding

Use this as a guide to replace or remove the rear case.

Use tweezers to completely remove the sticker from the rear of controller.
  • Use tweezers to completely remove the sticker from the rear of controller.

Voeg opmerking toe

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Voeg opmerking toe

  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

  • Use the plastic opening tool to pry the two cases apart.

Voeg opmerking toe

  • Remove the two rubber side grips.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Jefferson Hsu

Lid sinds: 18-09-12

408 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 1-7, Propen Fall 2012 Lid van Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 726