Inleiding
Use this as a guide to remove or replace the rubber part of the directional pad.
Wat je nodig hebt
-
-
Use tweezers to completely remove the sticker from the rear of controller.
-
-
-
-
Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
-
-
-
Use tweezers to remove the rubber part of the directional pad.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
2 andere personen hebben deze handleiding voltooid.
Team
Cal Poly, Team 1-7, Propen Fall 2012 Lid van Cal Poly, Team 1-7, Propen Fall 2012
CPSU-PROPEN-F12S1G7
4 Leden
14 handleidingen geschreven
2 opmerkingen
mi spiegate l'utilita di questa guida?vendere forse le pinzette e tutte le altre stronzatine che servono per riparare il fightpad?quando invece il pezzo più importante cioè il gommino non lo vendete....fate pena
Hi I don't speak Italian but I think you are asking "what is the purpose of this guide?". We made these as a project for university because I wanted to resolder a wire in this controller that came undone. For good measure we made a guide for each individual part although the real purpose of these guides was for the full disassembly and re soldering.
