Inleiding

Outline what you are going to teach someone how to do.

Onderdelen

Geen onderdelen nodig.

The battery compartment is located in the front-right side of the laptop.
  • The battery compartment is located in the front-right side of the laptop.

Voeg opmerking toe

To insert the battery, gently slide it into the compartment until it clicks in place.
  • To insert the battery, gently slide it into the compartment until it clicks in place.

  • To remove, slide the button highlighted in the red rectangle to the right to release the battery and slide it from the compartment.

This is not to remove the battery, this is to remove the expansion slot (which has got the floppy disk module in it, in the first picture.

blrutter - Antwoord

Sorry I should have mentioned it in my prior comment. The battery has got a release button on it too, but it’s part of the battery, exposed on the front face of the right front corner when the battery is installed.

blrutter - Antwoord

  • With the laptop upside down and with the battery removed, use a Torx #9 screw driver to remove the three .84 in. screws shown.

Voeg opmerking toe

  • Carefully pull up on the front of the keyboard to pop it out from the case.

  • Then slide the back out so the keyboard becomes nearly free.

Voeg opmerking toe

  • Disconnect the ribbon that is connecting the keyboard to the rest of the computer.

  • Pull the keyboard out and repair or replace as needed.

Voeg opmerking toe

  • Remove the front plastic panel of the laptop by carefully lifting it up.

If they haven’t been broken off (mine just did break as I was doing this) there is a tab on each side attached to the top housing on either side of the keyboard. These tabs are on top of the tabs for the front top panel, so lifting the front end of those side housings is necessary to prevent breakage (and, given how old these suckers are, it might break anyway).

blrutter - Antwoord

  • With a Torx #9 screwdriver, remove the three .30 in. screws that hold the metal frame in place.

Voeg opmerking toe

  • Remove the metal chasis that holds the hard drive.

Voeg opmerking toe

  • In order to remove the hard drive, remove the four .22 in. screws circled in red found on both sides of the metal chassis with a Torx #9 screwdriver.

Voeg opmerking toe

  • Pull the hard drive out.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Ronan

Lid sinds: 10-10-11

42 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 6-1, Regan Fall 2011 Lid van Cal Poly, Team 6-1, Regan Fall 2011

CPSU-REGAN-F11S6G1

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 1,058