Inleiding

Remove the lower case to access most components in your MacBook Pro 17" Unibody.

  1. Remove the following ten screws securing the lower case to the upper case:
    • Remove the following ten screws securing the lower case to the upper case:

      • Three 13.5 mm Phillips screws.

      • Seven 3 mm Phillips screws.

  2. Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.
    • Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.

      • During reassembly, carefully align the lower case and then press it firmly until both clips engage.

    • Remove the lower case.

Conclusie

To reassemble your device, follow these instructions in reverse order.

14 andere personen hebben deze handleiding voltooid.

Één commentaar

Is there a DIY on replacing the rubber feet?

retrotechpost - Antwoord

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 16

Afgelopen 30 Dagen: 49

Altijd: 15,378