Ga door naar hoofdinhoud

MacBook Air 11" Mid 2013 I/O Board Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. MacBook Air 11" Mid 2013 I/O Board Replacement, I/O Board: stap 1, afbeelding 1 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement, I/O Board: stap 1, afbeelding 2 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement, I/O Board: stap 1, afbeelding 3 van 3
    • Remove the small rubber gasket from the corner of the upper case nearest the the I/O board.

    • Remove the gasket from the corner nearest display cable connector.

  2. MacBook Air 11" Mid 2013 I/O Board Replacement: stap 2, afbeelding 1 van 2 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 2, afbeelding 2 van 2
    • If necessary, use tweezers to remove any tape covering the microphone cable ZIF connector.

  3. MacBook Air 11" Mid 2013 I/O Board Replacement: stap 3, afbeelding 1 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 3, afbeelding 2 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 3, afbeelding 3 van 3
    • Use the tip of a spudger to carefully flip up the retaining flap on the microphone cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    • With a pair of tweezers, pull the microphone ribbon cable straight out of its socket.

  4. MacBook Air 11" Mid 2013 I/O Board Replacement: stap 4, afbeelding 1 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 4, afbeelding 2 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 4, afbeelding 3 van 3
    • Use the tip of a spudger to pry under the speaker cable near the connector, lifting it straight up from its socket.

    • De-route the cable from its notch in the logic board.

  5. MacBook Air 11" Mid 2013 I/O Board Replacement: stap 5, afbeelding 1 van 1
    • Remove the single 3.6 mm T5 Torx screw securing the I/O board to the upper case.

  6. MacBook Air 11" Mid 2013 I/O Board Replacement: stap 6, afbeelding 1 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 6, afbeelding 2 van 3 MacBook Air 11" Mid 2013 I/O Board Replacement: stap 6, afbeelding 3 van 3
    • Carefully lift the I/O board by its power cable and pull it away from the edge of the case.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Lid sinds: 10/18/12

465.255 Reputatie

538 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

136 Leden

16.573 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 88