Ga door naar hoofdinhoud

Mac mini Late 2012 Fan Replacement

Wat je nodig hebt

  1. Mac mini Late 2012 Fan Replacement, Bottom Cover: stap 1, afbeelding 1 van 2 Mac mini Late 2012 Fan Replacement, Bottom Cover: stap 1, afbeelding 2 van 2
    • Place your thumbs in the depressions cut into the bottom cover.

    • Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.

    • You do not need to apply much downward pressure while turning.

  2. Mac mini Late 2012 Fan Replacement: stap 2, afbeelding 1 van 1
    • Tilt the mini enough to allow the bottom cover to fall away from the outer case.

    • Remove the bottom cover and set it aside.

  3. Mac mini Late 2012 Fan Replacement, Fan: stap 3, afbeelding 1 van 1
    • Remove the two 11.3 mm T6 Torx screws securing the fan to the logic board near the antenna plate.

  4. Mac mini Late 2012 Fan Replacement: stap 4, afbeelding 1 van 1
    • Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case.

    • Removing the standoff screw is not necessary to remove the fan. You need only raise the fan enough to lift it off the standoff screw.

  5. Mac mini Late 2012 Fan Replacement: stap 5, afbeelding 1 van 3 Mac mini Late 2012 Fan Replacement: stap 5, afbeelding 2 van 3 Mac mini Late 2012 Fan Replacement: stap 5, afbeelding 3 van 3
    • Lift the fan out of the mini for enough clearance to access its connector.

    • Grab all the wires at once and gently pull straight up to disconnect the fan from the logic board.

    • Do not pry at the socket, or you may rip it from the logic board.

    • Remove the fan.

Conclusie

To reassemble your device, follow these instructions in reverse order.

31 andere personen hebben deze handleiding voltooid.

Andrew Optimus Goldheart

Lid sinds: 10/17/09

501.535 Reputatie

407 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

134 Leden

16.042 handleidingen geschreven

3 opmerkingen

If you shouls happen to rip the connector off the logic board, just replace the end of the connector wire with a usb plug and the connect it to the computer, Vola

Reginald O'Brikis - Antwoord

What or where does the spring go on the long torque screw?

on the logic board, or the inner bevels on the screw?

[deleted] - Antwoord

where does the mini get input cooling air?? I can see the output ports but don't see any path for inputting cool air.

thanks..

pvpeel - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 4

Afgelopen 7 dagen: 22

Afgelopen 30 dagen: 131

Altijd: 27,736