Ga door naar hoofdinhoud

Mac Pro Late 2013 Power Supply Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Mac Pro Late 2013 Power Supply Assembly Replacement, Power Supply Assembly: stap 1, afbeelding 1 van 1
    • Flip the Mac Pro back over and set it gently on a flat surface.

    • We recommend laying the Mac Pro on the corner of the heat sink and the two standoff screw posts that attach to the interconnect board.

  2. Mac Pro Late 2013 Power Supply Assembly Replacement: stap 2, afbeelding 1 van 2 Mac Pro Late 2013 Power Supply Assembly Replacement: stap 2, afbeelding 2 van 2
    • Remove the two 3.6 mm T5 Torx screws from the sides of the power supply cage (one on each side).

  3. Mac Pro Late 2013 Power Supply Assembly Replacement: stap 3, afbeelding 1 van 1
    • Remove the power supply cage from the top of the power supply.

    • By removing this cage, you are exposing internal components of the power supply. Be very careful not to touch any of the power supply components or circuitry.

    • Be careful not to drop any screws or tools into the power supply, as this may damage the power supply.

  4. Mac Pro Late 2013 Power Supply Assembly Replacement: stap 4, afbeelding 1 van 1
    • Remove the four 5.5 mm T8 Torx screws securing the power supply assembly to the Mac Pro.

  5. Mac Pro Late 2013 Power Supply Assembly Replacement: stap 5, afbeelding 1 van 1
    • Remove the power supply assembly from the Mac Pro.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Lid sinds: 10/17/09

502.275 Reputatie

407 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

136 Leden

16.560 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 92