Ga door naar hoofdinhoud

Inleiding

Is your night vision too dark to view, or not working at all? Replacing your camera's Night Vision IR LEDs might solve these problems.

  1. Remove the six 10mm Torx T10 screws on the camera face. Remove the six 10mm Torx T10 screws on the camera face.
    • Remove the six 10mm Torx T10 screws on the camera face.

  2. Remove the exterior lens cover.
    • Remove the exterior lens cover.

  3. Remove the LED foam ring with tweezers. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.
    • Remove the LED foam ring with tweezers.

    • Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.

  4. Remove the two 5mm Phillips #1 screws. Remove the two 8mm Phillips #0 screws.
    • Remove the two 5mm Phillips #1 screws.

    • Remove the two 8mm Phillips #0 screws.

    • When reassembling, tighten the top and bottom 5mm screws first, followed by the left and right 8mm screws.

  5. Use  tweezers to unclip the cables to the LED board Use  tweezers to unclip the cables to the LED board
    • Use tweezers to unclip the cables to the LED board

Conclusie

To reassemble your device, follow these instructions in reverse order.

craig crisci

Lid sinds: 26-09-16

220 Reputatie

1 Handleiding geschreven

Team

USF Tampa, Team 16-1, Eyestone Fall 2016 Lid van USF Tampa, Team 16-1, Eyestone Fall 2016

USFT-EYESTONE-F16S16G1

4 Leden

12 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 10

Altijd: 660