Inleiding

Is your disco ball not sending out groovy beams of light anymore? The most common problem is the light bulb is burnt out. This guide will teach you how to replace that light bulb, so you can get back to partying!

Onderdelen

Geen onderdelen nodig.

  1. Unplug the device to avoid injury.
    • Unplug the device to avoid injury.

    • Turn the device over, so that the base is on top.

    Voeg opmerking toe

  2. Compress the tab by pushing towards the center of the device with a spudger.
    • Compress the tab by pushing towards the center of the device with a spudger.

    • While compressing the tab, peel the base away from the rotating head.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • If the metal brackets come off of the sphere, put them back on the plastic piece as shown in the photo.

    Voeg opmerking toe

    • Unscrew the burnt-out light bulb with a counter-clockwise twist.

    • Do not apply too much pressure when unscrewing light bulb, as the light bulb may break.

    Voeg opmerking toe

Eindstreep

3 andere personen hebben deze handleiding voltooid.

Nick Kaprielian

Lid sinds: 14-01-14

495 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 17-3, Forte Winter 2014 Lid van Cal Poly, Team 17-3, Forte Winter 2014

CPSU-FORTE-W14S17G3

5 Leden

7 handleidingen geschreven

Great! Wasn't sure how to remove the base. Thank you!

derigo1957 - Antwoord

Saved me a headache. Couldn't figure out how to remove base. Thanks!

mccullough1251 - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 4

Afgelopen 7 Dagen: 18

Afgelopen 30 Dagen: 127

Altijd: 7,159