Ga door naar hoofdinhoud

Onderdelen

Geen onderdelen opgegeven.

  1. Remove the eight 14mm screws using the Phillips #0 Screwdriver.
    • Remove the eight 14mm screws using the Phillips #0 Screwdriver.

  2. Lift the palm rest panel up.
    • Lift the palm rest panel up.

    • Be sure to lift the panel slowly; there is a ribbon cable attached to the bottom.

  3. Use the spudger to disconnect the ribbon cable.
    • Use the spudger to disconnect the ribbon cable.

  4. Remove the tape, using the spudger if necessary. Remove the tape, using the spudger if necessary.
    • Remove the tape, using the spudger if necessary.

  5. Disconnect the clear ribbon cable. Disconnect the clear ribbon cable.
    • Disconnect the clear ribbon cable.

  6. Use the Phillips #0 Screwdriver to remove the screws of the frame around the trackpad circuit board. Use the Phillips #0 Screwdriver to remove the screws of the frame around the trackpad circuit board.
    • Use the Phillips #0 Screwdriver to remove the screws of the frame around the trackpad circuit board.

  7. Remove the trackpad buttons. Remove the trackpad buttons.
    • Remove the trackpad buttons.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Matthew Fajardo

Lid sinds: 14-04-15

510 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 5-7, Maness Spring 2015 Lid van Cal Poly, Team 5-7, Maness Spring 2015

CPSU-MANESS-S15S5G7

4 Leden

6 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 9

Altijd: 1,773