Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.
  • Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.

  • These screens are held in place by glue and are hard to remove. Take your time.

Voeg opmerking toe

Remove the 3.14" Philips screws from both spots that were covered.
  • Remove the 3.14" Philips screws from both spots that were covered.

Voeg opmerking toe

Go all around the casing prying the screen away from the backing with a spudger.
  • Go all around the casing prying the screen away from the backing with a spudger.

  • It will make a popping sound each time one of the lock tabs is disconnected.

  • DO NOT USE A METAL TOOL FOR THIS.

  • Take your time as you move all around the device prying the backing off.

Voeg opmerking toe

Pull off the plastic covering the battery cable.
  • Pull off the plastic covering the battery cable.

Voeg opmerking toe

Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers. Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.
  • Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.

Voeg opmerking toe

Remove the battery by grabbing the tab shown and pulling up.
  • Remove the battery by grabbing the tab shown and pulling up.

  • The battery is held to the device by a bit of adhesive. Just pull the battery up from the tab and it will lift out with a bit effort.

Voeg opmerking toe

The speakers are connected to the tablet by glue and require a lot of prying to remove. Make sure to get all the way under the speakers when prying. Make sure to get all the way under the speakers when prying.
  • The speakers are connected to the tablet by glue and require a lot of prying to remove.

  • Make sure to get all the way under the speakers when prying.

Voeg opmerking toe

This step is not necessary if you aren't replacing the speakers. To the remove the wires heat the solder connecting the wires to the board, and gently pull on the wires.
  • This step is not necessary if you aren't replacing the speakers.

  • To the remove the wires heat the solder connecting the wires to the board, and gently pull on the wires.

  • Remember the placement of the red and black wires.

  • Connect new speakers by soldering the wires onto the board.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Josiah Speed

Lid sinds: 22-09-14

900 reputatie

4 handleidingen geschreven

Team

USF Tampa, Team 10-4, Brown Fall 2014 Lid van USF Tampa, Team 10-4, Brown Fall 2014

USFT-BROWN-F14S10G4

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 8

Altijd: 454