Inleiding

Steps to remove the LG VX8550 camera

Onderdelen

Geen onderdelen nodig.

Slide the battery release up.
  • Slide the battery release up.

Voeg opmerking toe

Remove the battery by lifting away from the case.
  • Remove the battery by lifting away from the case.

Voeg opmerking toe

  • Remove the 2 screw covers next to the rear speaker with a Push Pin.

Voeg opmerking toe

  • Remove the 4 cover screws with a Philips #00 screwdriver.

Voeg opmerking toe

  • Use the iPod opening tool to pry off the back casing.

Voeg opmerking toe

  • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

Voeg opmerking toe

  • Separate the casing halves.

  • Be sure to keep track of the side buttons as they fall out.

Voeg opmerking toe

  • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

Voeg opmerking toe

  • Carefully lift up on the motherboard to see the ribbon cables underneath.

  • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

Voeg opmerking toe

  • Remove the motherboard from the front casing by lifting straight up.

Voeg opmerking toe

  • Lay the phone with the screen facedown.

  • The 6 slider screws are visible.

Voeg opmerking toe

  • Peel back but don't remove the blue tape to access the 2 center screws.

  • Remove the 6 slider screws with the Phillips #00 screwdriver.

Voeg opmerking toe

  • Lift the keypad housing away from the slider.

Voeg opmerking toe

  • Remove the 2 screw covers next to the speaker with a push pin next to the camera.

Voeg opmerking toe

  • Remove the 6 screws with a Phillips #00 Screwdriver.

Voeg opmerking toe

  • Use the ipod opening tool to pry the screen casing and the slider mechanism apart from each other.

Voeg opmerking toe

  • Carefully lift the slider mechanism to see the ribbon cables underneath.

Voeg opmerking toe

  • Slide ribbon cable through the slider mechanism.

Voeg opmerking toe

  • Separate the two halves.

Voeg opmerking toe

  • With the screen casing separated from the slider mechanism the camera circuit board is visible.

  • Carefully lift up on the connector to unplug it from the circuit board.

Voeg opmerking toe

  • Lift up slowly on the connector cable to peel the camera off the adhesive backing.

Voeg opmerking toe

  • Remove camera from the casing.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Nathan Jones

Lid sinds: 10-04-10

83 Reputatie

10 handleidingen geschreven

Team

Cal Poly, Team 34-55, Forte Spring 2010 Lid van Cal Poly, Team 34-55, Forte Spring 2010

CPSU-FORTE-S10S34G55

5 Leden

20 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,304