Inleiding

A guide to removing the phone's main PCB.

  1. Turn the phone on its back.
    • Turn the phone on its back.

    Voeg opmerking toe

  2. Orient the phone as shown.
    • Orient the phone as shown.

    • Remove the battery cover by pushing upward with your thumb.

    Voeg opmerking toe

    • Place your fingernail at the top of the battery and pry the battery out towards you.

    Voeg opmerking toe

    • Orient the phone as shown with the battery already removed.

    Voeg opmerking toe

    • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

    • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

    Voeg opmerking toe

    • Place an iPod opener tool in the seam above the antenna.

    • Run the tool around the perimeter of the entire phone.

    Voeg opmerking toe

    • Check to see that your device looks like the attached photo.

    Voeg opmerking toe

    • Locate the tabs that hold the logic board in place.

    • Pull the outer frame of the phone outwards to release the board from the tabs.

    Voeg opmerking toe

    • Locate the copper connection (orange-colored) on the back of the board.

    • Pry the connector free from the board with your fingernail.

    Voeg opmerking toe

    • Check to see that your device looks like the image shown.

    • Note: The image is shown with the LCD screen removed. This is not necessary for logic board removal.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Douglas Blaalid

Lid sinds: 13-01-10

282 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 4-13, Forte Winter 2010 Lid van Cal Poly, Team 4-13, Forte Winter 2010

CPSU-FORTE-W10S4G13

5 Leden

15 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 2,560