Inleiding

This section covers how to disassemble the upper casing of the LG VX5200 to access the phone's screen.

Pry the grey pieces of plastic off the corners of the screen with a spudger. Pry the grey pieces of plastic off the corners of the screen with a spudger. Pry the grey pieces of plastic off the corners of the screen with a spudger.
  • Pry the grey pieces of plastic off the corners of the screen with a spudger.

Voeg opmerking toe

Unscrew each of the four screws with a Phillips #00 Screwdriver. These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.
  • Unscrew each of the four screws with a Phillips #00 Screwdriver.

  • These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.

  • These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.

Voeg opmerking toe

Mac RAM Kits
Versnel je Mac. Breid zijn geheugen uit.
Mac RAM Kits
Haal meer megabytes uit je Mac.
Close the phone after removing the screws. Slide a spudger into the cracks in the top half of the phone's casing.
  • Close the phone after removing the screws.

  • Slide a spudger into the cracks in the top half of the phone's casing.

  • Wedge and lever the spudger to remove the casing.

  • Apply constant pressure to avoid cracking the plastic casing. This step can take a few minutes.

Voeg opmerking toe

Remove the chipboard from the screen by sliding a plastic spudger under the screen and lifting. Use a plastic spudger to avoid short-circuiting the phone's electronics. Gently lift the speaker out of the plastic casing using a plastic spudger.
  • Remove the chipboard from the screen by sliding a plastic spudger under the screen and lifting.

  • Use a plastic spudger to avoid short-circuiting the phone's electronics.

  • Gently lift the speaker out of the plastic casing using a plastic spudger.

  • Remove the small battery adjacent to the speaker with a plastic spudger.

Voeg opmerking toe

Slide and lever a plastic spudger between the screen and it's housing. Avoid tearing the wires connecting the screen, the small battery and the speaker. Remove the chip connecting the screen to the camera using your fingers.
  • Slide and lever a plastic spudger between the screen and it's housing.

  • Avoid tearing the wires connecting the screen, the small battery and the speaker.

  • Remove the chip connecting the screen to the camera using your fingers.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

jmarcum

Lid sinds: 28-10-09

16 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 9-18, Regan Fall 2009 Lid van Cal Poly, Team 9-18, Regan Fall 2009

CPSU-REGAN-F09S9G18

5 Leden

4 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 3,210