Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

  1. Power down the phone by holding the power button for several seconds. While holding the battery release button, pull the bottom end of the phone out of the body. While holding the battery release button, pull the bottom end of the phone out of the body.
    • Power down the phone by holding the power button for several seconds.

    • While holding the battery release button, pull the bottom end of the phone out of the body.

  2. Separate the battery from bottom half. Insert the new battery in the same position and orientation as the old battery. Match up the arrows to be sure the orientation is correct.
    • Separate the battery from bottom half.

    • Insert the new battery in the same position and orientation as the old battery. Match up the arrows to be sure the orientation is correct.

  3. Remove the two 5.5mm Phillips #00 screws from the base of the phone. Remove the two 5.5mm Phillips #00 screws from the base of the phone.
    • Remove the two 5.5mm Phillips #00 screws from the base of the phone.

  4. Insert the plastic opening tool into the bottom seam Pry the plastic from the base only a slight amount.
    • Insert the plastic opening tool into the bottom seam

    • Pry the plastic from the base only a slight amount.

  5. Remove the one 5.5mm Phillips #000 screw. Remove the one 5.5mm Phillips #000 screw.
    • Remove the one 5.5mm Phillips #000 screw.

  6. Insert the plastic opening tool into the seam between the two plastic layers. Pry the plastic from the body. Pry the plastic from the body.
    • Insert the plastic opening tool into the seam between the two plastic layers.

    • Pry the plastic from the body.

  7. Insert the plastic opening tool into the seam under the metal charging port. Pry the metal charging port from the body.
    • Insert the plastic opening tool into the seam under the metal charging port.

    • Pry the metal charging port from the body.

Conclusie

To reassemble your device, follow these instructions in reverse order.

21 andere personen hebben deze handleiding voltooid.

Joshua Zalmanowitz

Lid sinds: 27-09-16

1.757 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 18-2, Forte Fall 2016 Lid van Cal Poly, Team 18-2, Forte Fall 2016

CPSU-FORTE-F16S18G2

4 Leden

15 handleidingen geschreven

I would love steps to show not only pulling out the usb port, but also putting the new one in and re-assembly. Also maybe tips about things to avoid doing -- easy slip ups people make when doing it. Why replace just the usb port instead of the whole board assembly or instead of the entire bottom module? Thanks! Great pics

jessicacollins267 - Antwoord

Anyone know how to bypass the "insert a supported module" error that comes up after changing the charging port?

Rene - Antwoord

Do you solve the problem? Can you help me, please?

Budai Daniel -

I need to do this repair on my phone, but Rene's comment worries me. Does this error message come up often? Can it be fixed?

Brad - Antwoord

Hello. I have the same problem like Rene . I changed the usb port and when I try to power on my smartphone it shows me the picture that said “insert a supported module” like what Rene said earlier. Please, I need help.

Budai Daniel - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 13

Afgelopen 30 dagen: 92

Altijd: 21,784