Inleiding

The trigger assembly that connects the button to the motor can sometimes break. This guide will explain how to replace the trigger assembly.

Onderdelen

Geen onderdelen nodig.

In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.
  • In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

Voeg opmerking toe

Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.
  • Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.

  • Try not to break these clips as this will cause structural integrity issues upon reassembly

Hello I need to remove the base as described here to repair th power cord in side. I got 2 of the clips cleared to lift off the base using the spudger, but just can’t get the other 2 released. Any ideas? Thanks

Steve Ferrill - Antwoord

Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate. Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.
  • Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

Voeg opmerking toe

The trigger button is held in with light tension clips. Gently pry them back to release.
  • The trigger button is held in with light tension clips. Gently pry them back to release.

Voeg opmerking toe

Remove the white trigger. Remove the white trigger.
  • Remove the white trigger.

Voeg opmerking toe

Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button
  • Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button

  • Be sure to reference the how to solder video posted to the device page

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Ian Hancock

Lid sinds: 22-10-14

372 reputatie

3 handleidingen geschreven

Team

Baylor, Team 4-2, Williams Fall 2014 Lid van Baylor, Team 4-2, Williams Fall 2014

BU-WILLIAMS-F14S4G2

3 Leden

4 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 15

Afgelopen 30 Dagen: 58

Altijd: 1,732