Inleiding

Use this guide to replace a faulty lid switch on your Kenmore 110 series washing machine.

  1. To avoid risk of electric shock, unplug the washing machine.
    • To avoid risk of electric shock, unplug the washing machine.

    • Using a 5/16" socket wrench or an adjustable wrench, remove the three screws from the top rear of the washer.

    • Lifting from the rear, remove the top panel.

    • Set the top panel on its rear face, with its underside facing you.

    • The top panel will still be connected to the washer by wires and hoses. It will help if you have a flat raised surface to set the top panel on.

  2. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  3. Using a 5/16" socket wrench or hand wrench, remove the two screws from the component cover. Gripping from the bottom, pull the component cover out of the washer.
    • Using a 5/16" socket wrench or hand wrench, remove the two screws from the component cover.

    • Gripping from the bottom, pull the component cover out of the washer.

  4. Carefully unplug the two wires connected to the lid switch. Remove the two Phillips screws securing the bracket. Remove the green ground wire.
    • Carefully unplug the two wires connected to the lid switch.

    • Remove the two Phillips screws securing the bracket.

    • Remove the green ground wire.

    • With a screwdriver, remove the single screw connecting the lid switch to the bracket.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Robert Trout

Lid sinds: 26-09-12

845 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 15-43, Forte Fall 2012 Lid van Cal Poly, Team 15-43, Forte Fall 2012

CPSU-FORTE-F12S15G43

5 Leden

5 handleidingen geschreven

My Kenmore Model 110.24622300 does NOT look anything like this!

rlhaan36 - Antwoord

my model # 11088732796 is not the same as yours

glafleur1 -

No it ia neither of those. Thank for the reply though. My washer is a 90 series.

Jenn Leffring -

Lol I found the solution on YouTube. All it takes is a zip tie because the lid switch for he 90s series Kenmore washer is two half pieces glued together

Jenn Leffring - Antwoord

my Kenmore washer model# is 110.24812200; series CP2654205. Cannot remove top to repair lid switch following your video! removed the three screwsf from the back but cannot get control panal to come off! Please reply soon.

bill wardle - Antwoord

Weergavestatistieken:

Afgelopen 24 Uren: 26

Afgelopen 7 Dagen: 139

Afgelopen 30 Dagen: 572

Altijd: 65,871