Inleiding

This guide shows you how to replace the spring on the power button.

Onderdelen

Geen onderdelen nodig.

Turn the device upside down so that the three rubber pads are facing up.
  • Turn the device upside down so that the three rubber pads are facing up.

Voeg opmerking toe

Use a heat gun (set to low) to apply heat  to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.
  • Use a heat gun (set to low) to apply heat to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.

Voeg opmerking toe

Remove the heated rubber pad with a plastic opening tool.
  • Remove the heated rubber pad with a plastic opening tool.

  • Repeat steps 2 and 3 for the two remaining rubber pads.

Voeg opmerking toe

Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver. Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.
  • Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.

Voeg opmerking toe

Open the device along its seam. Be careful when separating the device because there are wires connecting the two seperate halves. Be careful when separating the device because there are wires connecting the two seperate halves.
  • Open the device along its seam.

  • Be careful when separating the device because there are wires connecting the two seperate halves.

Voeg opmerking toe

Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.
  • Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.

Voeg opmerking toe

Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device. Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.
  • Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.

Where do I find these speakers

HighChief - Antwoord

Pull the plastic button off the post. Pull the plastic button off the post.
  • Pull the plastic button off the post.

Voeg opmerking toe

Remove the metal U-clip (compressing the spring) with tweezers.
  • Remove the metal U-clip (compressing the spring) with tweezers.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Janessa D Cabrera

Lid sinds: 23-01-14

478 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 9-28, Maness Winter 2014 Lid van Cal Poly, Team 9-28, Maness Winter 2014

CPSU-MANESS-W14S9G28

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 18

Altijd: 1,294