Inleiding

Does your case have a crack? Want to clean out some dust or dirt trapped underneath the screen? This guide will help you take the front cover off.

Onderdelen

Geen onderdelen nodig.

Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.
  • Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.

Voeg opmerking toe

Detach the back cover by carefully pulling up and out on the back plastic casing. Do not pull apart the red wire connecting the battery to the device.
  • Detach the back cover by carefully pulling up and out on the back plastic casing.

  • Do not pull apart the red wire connecting the battery to the device.

Voeg opmerking toe

Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.
  • Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.

  • Be careful to not tear the wires while opening the case.

Voeg opmerking toe

Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.
  • Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.

  • Do not disconnect wires from plastic connector.

Voeg opmerking toe

Remove the four corner plastic covers on the back of the device using the plastic opening tool. Remove the four corner plastic covers on the back of the device using the plastic opening tool.
  • Remove the four corner plastic covers on the back of the device using the plastic opening tool.

Voeg opmerking toe

Using a Philips #00 screwdriver remove all four 4.5mm  corner screws located underneath the corner pads.
  • Using a Philips #00 screwdriver remove all four 4.5mm corner screws located underneath the corner pads.

Voeg opmerking toe

Carefully wedge the plastic opening tool into either long side of the device. Slowly move the plastic opening tool along the side of the device, separating the front and back case covers. Repeat these steps on the other side of the device.
  • Carefully wedge the plastic opening tool into either long side of the device.

  • Slowly move the plastic opening tool along the side of the device, separating the front and back case covers.

  • Repeat these steps on the other side of the device.

Voeg opmerking toe

Once the front cover is loose, use your fingers to remove the front case cover for a new installation.
  • Once the front cover is loose, use your fingers to remove the front case cover for a new installation.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Wesley Ballar

Lid sinds: 18-04-13

88 reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 12-36, Amido Spring 2013 Lid van Cal Poly, Team 12-36, Amido Spring 2013

CPSU-AMIDO-S13S12G36

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 1

Altijd: 193