Repareer je spullen Gemeenschap Winkel

Deze versie kan foutieve bewerkingen bevatten. Schakel over naar de recentste gecontroleerde momentopname.

Wat je nodig hebt

  1. Deze stap is niet vertaald. Help het te vertalen

    : stap 1, afbeelding 1 van 1

    • Power off your laptop before beginning disassembly.

    • Open the laptop to locate the keyboard.

    Vertaal

  2. Deze stap is niet vertaald. Help het te vertalen

    : stap 2, afbeelding 1 van 2 : stap 2, afbeelding 2 van 2

    • Insert a plastic opening tool in the seam between the keyboard and laptop body.

    • Carefully run the tool around the top and sides of the keyboard to pop out the 9 tabs holding in the keyboard.

    Vertaal

  4. Deze stap is niet vertaald. Help het te vertalen

    : stap 3, afbeelding 1 van 3 : stap 3, afbeelding 2 van 3 : stap 3, afbeelding 3 van 3

    • Lift the keyboard up, then pivot it towards you to lay it facedown on the trackpad and palm rests.

    • Be careful when lifting the keyboard up. The ribbon cable connecting it to the motherboard is very short, and the connector is fragile.

    • The top corners of the keyboard may be stuck to the laptop bezel with double sided tape. See rectangles in Image 3. Be careful as you lift the keyboard up and pivot it toward you.

    Vertaal

    My keyboard was also stuck down with double sided tape near the sides 1cm down from the top edge. These didn't want to let go easily, be careful pulling them away.

    Frank Puranik - Antwoord

    Also, on my keyboard there are metal latches under the keyboard. To remove the keyboard it needs to be slid towards the screen a few mm before you can lift it. When reassembling do the reverse, engaging the latches, or the keyboard will not stay down properly.

    Frank Puranik - Antwoord

  5. Deze stap is niet vertaald. Help het te vertalen

    : stap 4, afbeelding 1 van 3 : stap 4, afbeelding 2 van 3 : stap 4, afbeelding 3 van 3

    • Locate the ribbon cable connecting the keyboard to the motherboard.

    • Use the tip of the opening tool to lift the black flap on the connector.

    • With the twezers, gently lift the ribbon cable out of the connector.

    • Be careful when reinserting the ribbon cable.

    • Ensure the cutouts on the end of the cable match the tabs on the connector.

    Vertaal

    The cable is not lifted . It should be pulled parallel to the line of the memory chips. The Lenovo service guide makes this clear.

    Frank Puranik - Antwoord

    Getting the cable back i was tricky. in the end I almost had the keyboard vertical to east the bend on the connector as I pushed it back in gently - then it finally went in. When you push the retaining flap back down the white line on the ribbon cable should just be showing - then you have it in properly.

    Frank Puranik - Antwoord

    also you may think you’ve not got the cable in enough but actually when you flip the tab down if you can see about a.1.5mm of cable above the white line you should be good. just turn on the computer to check keyboard works before screwing back together

    Tollon Adkins - Antwoord

    where can i buy original battery for my lenovo yoga 13 ideapad in gurgaon?

    Premlata - Antwoord

Eindstreep

4 andere personen hebben deze handleiding voltooid.

2 opmerkingen

Best tutorial for Lenovo Yoga 13 keyboard replacement !

Saved my Yoga 13 . Thanks a lot.

djibe - Antwoord

Unfortunately my ribbon cable connector lock snapped and I'm having trouble ensuring all connector ports are established. Tried using electrical tape but doesn't seem to work. Be grateful for any advice

robbarry89 - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 10

Altijd: 8,560