Ga door naar hoofdinhoud

Husqvarna Trimmer Carburetor Replacement

Wat je nodig hebt

  1. Husqvarna Trimmer Carburetor Replacement, Husqvarna Trimmer Carburetor: stap 1, afbeelding 1 van 1
    • Allow time for the engine to cool before beginning this procedure.

    • Using your fingers, unscrew the air filter bolt and remove it from the filter cover.

  2. Husqvarna Trimmer Carburetor Replacement: stap 2, afbeelding 1 van 3 Husqvarna Trimmer Carburetor Replacement: stap 2, afbeelding 2 van 3 Husqvarna Trimmer Carburetor Replacement: stap 2, afbeelding 3 van 3
    • Pull off the filter cover to reveal the air filter.

    • Remove the air filter from the filter housing.

  3. Husqvarna Trimmer Carburetor Replacement: stap 3, afbeelding 1 van 2 Husqvarna Trimmer Carburetor Replacement: stap 3, afbeelding 2 van 2
    • Remove two 8mm nuts with an 8mm socket attached to a 1/4" ratchet turning the nuts counterclockwise.

  4. Husqvarna Trimmer Carburetor Replacement: stap 4, afbeelding 1 van 2 Husqvarna Trimmer Carburetor Replacement: stap 4, afbeelding 2 van 2
    • Slide the choke lever to the full choke position.

  5. Husqvarna Trimmer Carburetor Replacement: stap 5, afbeelding 1 van 3 Husqvarna Trimmer Carburetor Replacement: stap 5, afbeelding 2 van 3 Husqvarna Trimmer Carburetor Replacement: stap 5, afbeelding 3 van 3
    • Remove the plastic housing by pulling it away from the device.

  6. Husqvarna Trimmer Carburetor Replacement: stap 6, afbeelding 1 van 2 Husqvarna Trimmer Carburetor Replacement: stap 6, afbeelding 2 van 2
    • Pull the carburetor off of the bolts.

  7. Husqvarna Trimmer Carburetor Replacement: stap 7, afbeelding 1 van 3 Husqvarna Trimmer Carburetor Replacement: stap 7, afbeelding 2 van 3 Husqvarna Trimmer Carburetor Replacement: stap 7, afbeelding 3 van 3
    • Detach the throttle cable from the carburetor by tilting it 90 degrees and pulling up.

  8. Husqvarna Trimmer Carburetor Replacement: stap 8, afbeelding 1 van 2 Husqvarna Trimmer Carburetor Replacement: stap 8, afbeelding 2 van 2
    • Remove the two fuel lines attached to the bottom of the carburetor using a set of needle nose pliers.

    • Gas may splash when removing fuel lines.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 19

Afgelopen 30 dagen: 85

Altijd: 1,972