Ga door naar hoofdinhoud

Huawei P9 Back Cover

Wat je nodig hebt

  1. Huawei P9 Back Cover, Back Cover: stap 1, afbeelding 1 van 3 Huawei P9 Back Cover, Back Cover: stap 1, afbeelding 2 van 3 Huawei P9 Back Cover, Back Cover: stap 1, afbeelding 3 van 3
    • First switch off your phone and remove the SIM card tray.

    • Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.

    • If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

  2. Huawei P9 Back Cover: stap 2, afbeelding 1 van 2 Huawei P9 Back Cover: stap 2, afbeelding 2 van 2
    • Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

    • Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

    • In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

    • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

  3. Huawei P9 Back Cover, Fingerprint sensor: stap 3, afbeelding 1 van 2 Huawei P9 Back Cover, Fingerprint sensor: stap 3, afbeelding 2 van 2
    • Disconnect the fingerprint sensor using a spudger.

Conclusie

To reassemble your device, follow these instructions in reverse order.

7 andere personen hebben deze handleiding voltooid.

Tobias Isakeit

Lid sinds: 03/31/14

116.764 Reputatie

188 handleidingen geschreven

Team

Master Techs Lid van Master Techs

Community

322 Leden

2.506 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 16

Altijd: 8,927