Ga door naar hoofdinhoud

Inleiding

Guide how to open the chasis of Cisco 878 Integrated Services Router.

Onderdelen

Geen onderdelen opgegeven.

  1. Only trained and qualified personnel should be allowed to install, replace, or service this equipment! During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself! Make sure that the power switch is turned to standby and that the power supply cable is disconnected. Disconnect all cables from the router back panel.
    • Only trained and qualified personnel should be allowed to install, replace, or service this equipment!

    • During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself!

    • Make sure that the power switch is turned to standby and that the power supply cable is disconnected. Disconnect all cables from the router back panel.

    • Use the Phillips #1 Screwdriver to remove the two screws on back side of the device.

  2. 1. Gently push the top cover of the router away from you. 2. Lift it up top cover from the bottom of the router. 3. Remove top cover from the device.
    • 1. Gently push the top cover of the router away from you.

    • 2. Lift it up top cover from the bottom of the router.

    • 3. Remove top cover from the device.

    • Place the router bottom on an antistatic mat.

  3. PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen

    PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen
  4. Use the Phillips #1 Screwdriver to remove the three screws on front side of the device. Use the Phillips #1 Screwdriver to remove the three screws on front side of the device.
    • Use the Phillips #1 Screwdriver to remove the three screws on front side of the device.

  5. 1. Gently lift up inner metal shield from the bottom of the router. 2. Remove inner metal shield from the device (see the anchors on the picture). Be careful and do not distort the plates!
    • 1. Gently lift up inner metal shield from the bottom of the router.

    • 2. Remove inner metal shield from the device (see the anchors on the picture).

    • Be careful and do not distort the plates!

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Jiri Altman

Lid sinds: 03-05-16

1.419 Reputatie

8 handleidingen geschreven

Team

4k20 Repair Team Lid van 4k20 Repair Team

Community

6 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 1

Altijd: 166