Repareer je spullen

Recht op reparatie

Winkel

How to clean out a Black and Decker Toast R Oven

Geschreven door: Jonathan (en 8 andere bijdragers)
  • Reacties: 2
  • Favorieten: 3
  • Voltooide reparaties: 3

Moeilijkheid

Gemiddeld

Stappen

13

Tijd vereist

30 minuten

Secties

1

Markeringen

1

Slice and Dice

Knip- en plakwerk

De stappen in deze handleiding moet worden opgesplitst in een reeks van vereiste handleidingen.

Inleiding

Sometimes a burning smell can come form the toaster. This could be caused by crumbs stuck in the unit so its suggested that you deep clean the Black and Decker Toast R Oven.

Gereedschap

Koop deze gereedschappen

Onderdelen

Geen onderdelen opgegeven.

  1. Make sure that the toaster is unplugged before you begin.

    • Make sure that the toaster is unplugged before you begin.

    • Turn the toaster over with its backside face down.

    • Remove the two Phillips #4 1cm screws that attach the side panels.

    Bewerken

  2. Pull downwards (towards the bottom of the unit) and outward to remove the side panels. Pull downwards (towards the bottom of the unit) and outward to remove the side panels.

    • Pull downwards (towards the bottom of the unit) and outward to remove the side panels.

    Bewerken

  3. Remove the metal vent piece that is below the door.

    • Remove the metal vent piece that is below the door.

    • This should slide off easily once both of the side panels are removed.

    Bewerken

  4. Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.

    • Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.

    Bewerken

  5. Remove the crumb tray (the bottom, metal panel) from the toaster unit.

    • Remove the crumb tray (the bottom, metal panel) from the toaster unit.

    Bewerken

  6. De essentiële toolkit

    De meest behulpzame tools in onze meest compacte kit.

    Koop nu

    De essentiële toolkit

    De meest behulpzame tools in onze meest compacte kit.

    Koop nu

  7. Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.

    • Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.

    Bewerken

  8. Remove the knobs by pulling them upward; they should slide right off.

    • Remove the knobs by pulling them upward; they should slide right off.

    • When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.

    Bewerken

  9. Unhook the bottom of the the display panel from the toaster unit.

    • Unhook the bottom of the the display panel from the toaster unit.

    • It will be a little tough to pry off, but don't be afraid to be forceful. You can use your hands, or pliers, to bend the metal piece backwards.

    Bewerken

  10. Begin to detach the back panel from the toaster unit.

    • Begin to detach the back panel from the toaster unit.

    • Then, unhook the rest of the display panel.

    • This will also be a little tough to get off, but don't be afraid to be forceful.

    Bewerken

  11. Now, you can clean the outside units of the toaster oven.

    • Now, you can clean the outside units of the toaster oven.

    Bewerken

  12. Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.

    • Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.

    Bewerken

  13. Finish removing the outside cover by lifting the lid upward.

    • Finish removing the outside cover by lifting the lid upward.

    Bewerken

  14. Remove the four Phillips #4 1 cm screws from the back of the unit.

    • Remove the four Phillips #4 1 cm screws from the back of the unit.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Auteur

met 8 andere bijdragers

Jonathan

Lid sinds: 18-09-12

224 Reputatie

5 handleidingen geschreven

Badges: 9

+6 andere badges

Team

Cal Poly, Team 2-10, Propen Fall 2012 Lid van Cal Poly, Team 2-10, Propen Fall 2012

CPSU-PROPEN-F12S2G10

4 Leden

5 handleidingen geschreven

0 Opmerkingen

Voeg een opmerking toe

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 4

Afgelopen 7 dagen: 28

Afgelopen 30 dagen: 130

Altijd: 11,652