How to Replace a Transition Strip (T Molding)

Inleiding

Use this guide to replace a T molding. A T molding is a transition strip used to connect two floorings at the same height.

A loose/ broken T molding can become a hazard as it might cause someone to trip over. Dirt can also add up under the transition strip, making it difficult to clean.

Step 2 of this guide requires measuring and cutting the T molding. Make sure to perform step 1 before purchasing your new T molding so that the place of purchase can cut it for free.

Wat je nodig hebt

Stap 1 Transition Strip (T Molding)

How to Replace a Transition Strip (T Molding), Transition Strip (T Molding): stap 1, afbeelding 1 van 1

Measure the exact width of the doorway using a tape measure.

Bewerken

Stap 2

How to Replace a Transition Strip (T Molding): stap 2, afbeelding 3 van 3

Mark the T molding based on the doorway measure.
Cut the T molding using a sharp saw (table saw).
Cutting the T molding can be done for free at the place of purchase.
If you don't have access to a sharp saw, cut the T molding using a jigsaw and use sanding paper to soften the end.

Bewerken

Stap 3

How to Replace a Transition Strip (T Molding): stap 3, afbeelding 3 van 3

Remove the old T molding.
You can use a pry bar to loosen the T molding.

Bewerken

Stap 4

Use a utility knife to remove all the glue or any material used to keep the old T molding in place.
You may use a scraper instead of a utility knife.
Clean up the area thoroughly.