How to Remove and Clean the Kenmore 575-0 Float Switch

Inleiding

In this tutorial, we'll cover every step of how to take out and clean the float switch from your Kenmore 575-0 dishwasher. A malfunctioning float switch can lead to water-related problems, disrupting the dishwasher's function and potentially causing costly damage.

This manual is available to help if the float assembly on your Kenmore 575-0 dishwasher needs cleaning or maintenance. This guide focuses on simple methods for removing and cleaning your dishwasher's float assembly, in contrast to certain techniques that require complicated steps.

Wat je nodig hebt

Stap 1 How to Remove and Clean the Kenmore 575-0 Float Switch

How to Remove and Clean the Kenmore 575-0 Float Switch, How to Remove and Clean the Kenmore 575-0 Float Switch: stap 1, afbeelding 1 van 3

How to Remove and Clean the Kenmore 575-0 Float Switch, How to Remove and Clean the Kenmore 575-0 Float Switch: stap 1, afbeelding 2 van 3

How to Remove and Clean the Kenmore 575-0 Float Switch, How to Remove and Clean the Kenmore 575-0 Float Switch: stap 1, afbeelding 3 van 3

To easily access the float assembly, open the dishwasher and carefully slide out the lower rack.
To prevent accidents, make sure the dishwasher is disconnected from both power and water sources.

Bewerken

Stap 2

How to Remove and Clean the Kenmore 575-0 Float Switch: stap 2, afbeelding 3 van 3

Use a Phillips #1 screwdriver to remove two 5 mm screws from the ends of the bottom cover of the dishwasher.
Remove the bottom cover.

Bewerken

Stap 3

How to Remove and Clean the Kenmore 575-0 Float Switch: stap 3, afbeelding 3 van 3

Loosen the single 5 mm screw at the base of the dishwasher that secures the float switch in place using a Phillips #1 screwdriver.
This will enable you to lift, remove, and clean the float located inside the dishwasher beneath the lower rack.
Ensure that the lever inside the float switch remains in its position and does not displace when you unscrew the float switch.

Bewerken

Stap 4

How to Remove and Clean the Kenmore 575-0 Float Switch: stap 4, afbeelding 3 van 3

Find the float assembly positioned near the front, underneath the lower rack.
Carefully press on top of the float assembly and then release to elevate the float.
Avoid excessive force when lifting, as it may result in damage to the float.

Bewerken

Stap 5

Check the float for any debris or residue. If it's dirty, clean it thoroughly with warm, soapy water and a soft brush. Also, clean the area where the float was installed.

Bewerken

Stap 6

How to Remove and Clean the Kenmore 575-0 Float Switch: stap 6, afbeelding 3 van 3

Reconnect the float assembly to its initial position and fasten it securely. Verify that it moves smoothly and without obstruction.
Now that the float switch is clean, reinsert the lower rack.
Reassemble the base of the dishwasher.
Close the dishwasher and turn on the power and water.