Repareer je spullen Gemeenschap Winkel

Hover-1 Matrix Pad Replacement

Inleiding

The pads on Hover-1 Matrix are weight sensitive, so when they sense weight, the hover board starts to move automatically. Overused pads must be replaced for the Hover-1 Matrix to move when there is a rider.

Wat je nodig hebt

  1. Hover-1 Matrix Pad Replacement, Pad: stap 1, afbeelding 1 van 2 Hover-1 Matrix Pad Replacement, Pad: stap 1, afbeelding 2 van 2

    • Remove the screws on the back of the hoverboard using a Phillips #1 screwdriver.

    • Remove the back shell from the hoverboard.

    Vertaal

  2. Hover-1 Matrix Pad Replacement: stap 2, afbeelding 1 van 1

    • Remove the screws from the metal layer inside the hoverboard using a Phillips #1 screwdriver.

    Vertaal

  4. Hover-1 Matrix Pad Replacement: stap 3, afbeelding 1 van 1

    • Separate the upper shell of the hoverboard and the metal layer inside.

    Vertaal

  5. Hover-1 Matrix Pad Replacement: stap 4, afbeelding 1 van 2 Hover-1 Matrix Pad Replacement: stap 4, afbeelding 2 van 2

    • Start by identifying the motherboard, which is the green pad shown in the picture.

    • Remove the screws on the corners of the motherboard with the Phillips #1 screwdriver and take it off.

    • There are cables attached to the motherboard so go ahead and unattach them.

    Vertaal

  6. Hover-1 Matrix Pad Replacement: stap 5, afbeelding 1 van 3 Hover-1 Matrix Pad Replacement: stap 5, afbeelding 2 van 3 Hover-1 Matrix Pad Replacement: stap 5, afbeelding 3 van 3

    • Use picture 1 as a guide and move the motherboard to the other side.

    • Identify the two black rubber buttons that are shown in the second picture.

    • Remove the two rubber buttons using the Phillips #1 screwdriver.

    Vertaal

  7. Hover-1 Matrix Pad Replacement: stap 6, afbeelding 1 van 1

    • Removing the rubber buttons in the previous step allows you to take the pad off.

    • Finally, take off the old pad and put on a new pad.

    Vertaal
Conclusie

To reassemble your device, follow these instructions starting with step number 6 and finishing with step number 1.

Één andere persoon heeft deze handleiding voltooid.

Auteur

met 4 andere bijdragers

Jici Zhuang

Lid sinds: 10/22/18

362 Reputatie

2 handleidingen geschreven

Medailles: 6

+3 andere badges

Team

UC Davis, Team S7-G2, Lore Fall 2018 Lid van UC Davis, Team S7-G2, Lore Fall 2018

UCD-LORE-F18S7G2

3 Leden

4 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 7

Altijd: 338