Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

After extended use, the motherboard may become defunct and the device may require a new piece.

  1. Remove the back cover of the device using the plastic opening tool. Pry open a corner of the device, then continue down the side with the tool to open the device. Pry open a corner of the device, then continue down the side with the tool to open the device.
    • Remove the back cover of the device using the plastic opening tool.

    • Pry open a corner of the device, then continue down the side with the tool to open the device.

  2. Remove the black tape located to the left of the device. Remove the clear tape directly below the camera.
    • Remove the black tape located to the left of the device.

    • Remove the clear tape directly below the camera.

  3. SLA DE UPGRADE OVER

    Bespaar door het te repareren met een alles-in-één kit.

    Koop iPhone-reparatiekits

    SLA DE UPGRADE OVER

    Bespaar door het te repareren met een alles-in-één kit.

    Koop iPhone-reparatiekits
  4. Remove the 4.43mm screws located at the top of the device using the Philips #00 screwdriver.
    • Remove the 4.43mm screws located at the top of the device using the Philips #00 screwdriver.

    • There is no need to remove the bottom two screws holding the speakers in place.

  5. Unlock the three ribbon cable connector latches to remove the cables.
    • Unlock the three ribbon cable connector latches to remove the cables.

  6. Be cautious of the extremely hot tip of the soldering iron. Unsolder the red, black, and yellow wires to remove the motherboard. Take a look at this guide to learn how to solder and unsolder connections. Unsolder the black wire located on the top left of the device.
    • Be cautious of the extremely hot tip of the soldering iron.

    • Unsolder the red, black, and yellow wires to remove the motherboard. Take a look at this guide to learn how to solder and unsolder connections.

    • Unsolder the black wire located on the top left of the device.

    • Once unsoldered, carefully lift the motherboard out of the device.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Katharina

Lid sinds: 23-02-15

503 Reputatie

2 handleidingen geschreven

Team

USF Tampa, Team 1-2, Leahy Winter 2015 Lid van USF Tampa, Team 1-2, Leahy Winter 2015

USFT-LEAHY-W15S1G2

3 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 9

Altijd: 1,163