Inleiding

This guide will walk you through how to replace your button pad.

  1. Remove the outer screen cover by releasing  the top clip from the main body of the device.
    • Remove the outer screen cover by releasing the top clip from the main body of the device.

    Voeg opmerking toe

  2. Pull out the stylus from the top right corner of the device.
    • Pull out the stylus from the top right corner of the device.

    Voeg opmerking toe

    • Slide the memory cartridge cover up and off the device.

    Voeg opmerking toe

    • Remove the battery cover by releasing the clip from the main body of the device.

    Voeg opmerking toe

    • Remove the batteries from the device.

    Voeg opmerking toe

    • Unscrew the four 2.94mm screws with a #00 Phillips screwdriver.

    • One end of the OEM stylus can unscrew and contains a mini #00 Phillips screwdriver.

    Voeg opmerking toe

    • Use the spudger to pry open the casing by applying pressure at 4 clips on both sides of the device.

    • Be careful while opening the casing as there is a flex strip connecting the two halves.

    Voeg opmerking toe

    • Disconnect the flex strip from the motherboard with tweezers.

    Voeg opmerking toe

    • Use tweezers to remove the power button from the back case.

    Voeg opmerking toe

    • Disconnect the button pad by using the spudger to pry it off the motherboard.

    • Remove the button pad.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

David Faltemier

Lid sinds: 20-06-12

19 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 1-2, Regan SU 2012 Lid van Cal Poly, Team 1-2, Regan SU 2012

CPSU-REGAN-SU12S1G2

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 440