Ga door naar hoofdinhoud

Handset Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Handset Replacement, Battery: stap 1, afbeelding 1 van 2 Handset Replacement, Battery: stap 1, afbeelding 2 van 2
    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

  2. Handset Replacement: stap 2, afbeelding 1 van 1
    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

  3. Handset Replacement, Handset: stap 3, afbeelding 1 van 1
    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

  4. Handset Replacement: stap 4, afbeelding 1 van 2 Handset Replacement: stap 4, afbeelding 2 van 2
    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

  5. Handset Replacement: stap 5, afbeelding 1 van 2 Handset Replacement: stap 5, afbeelding 2 van 2
    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Caleb Thomas

Lid sinds: 09/29/16

161 Reputatie

2 handleidingen geschreven

Team

IUPUI, Team 3-3, Harley Fall 2016 Lid van IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Leden

17 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 50