Hamilton-T1 Oxygen Cells Replacement - iFixit reparatiehandleiding

Inleiding

This guide is created for the replacement of oxygen cells in the Hamilton-T1 Ventilator. Replacing the oxygen cells is a crucial step in maintaining and keeping a working ventilator.

NOTE:

Replace the oxygen cell with genuine Hamilton Medical parts only; otherwise, oxygen measurement will not function. To prevent a permanent alarm make sure to use special Hamilton Medical oxygen cells only.
To prevent leakage within the ventilator, make sure an oxygen cell is installed at all times, even if you use an external monitor or disable oxygen monitoring.

Wat je nodig hebt

Stap 1 Oxygen Cells

Hamilton-T1 Oxygen Cells Replacement, Oxygen Cells: stap 1, afbeelding 1 van 1

Flip device around until the back panel is exposed.

Stap 2

Hamilton-T1 Oxygen Cells Replacement: stap 2, afbeelding 1 van 1

Remove the screw in the bottom center of the panel, and then take the panel off.

Stap 3

Hamilton-T1 Oxygen Cells Replacement: stap 3, afbeelding 1 van 1

Disconnect the oxygen cell by removing the tube.
Then twist the cell counter-clockwise and pull to remove the oxygen cell.
Install the new oxygen cell and put the back cover on.

Stap 4

After the cell is installed. Run the oxygen cell calibration.
Oxygen calibration guide can be found in 3-11 of the Hamilton-T1 operations manual.

Conclusie

After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.

Bijgevoegde documenten

HAMILTON-T1 Operator's Manual SW2.1x EN

PDF - 4.17 mb

Bekijk

Auteur

met 1 andere bijdrager

Tyler

Lid sinds: 04/09/20

114 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team S11-G24, Paton Spring 2020 Lid van Cal Poly, Team S11-G24, Paton Spring 2020

CPSU-PATON-S20S11G24

3 Leden

3 handleidingen geschreven

0 opmerkingen

Weergavestatistieken:

Afgelopen 24 uren: 3

Afgelopen 7 dagen: 17

Afgelopen 30 dagen: 53

Altijd: 2,213