HTC myTouch 3G Motherboard Replacement

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

Inleiding

This guide describes the steps to separate the HTC myTouch motherboard from the glass screen for replacement or repair. This guide will require you to unscrew a T5 Torx screw with a VOID label. Unfastening this screw would void any warranty the phone may have.

Wat je nodig hebt

Stap 1 Motherboard

HTC myTouch 3G Motherboard Replacement, Motherboard: stap 1, afbeelding 1 van 2

HTC myTouch 3G Motherboard Replacement, Motherboard: stap 1, afbeelding 2 van 2

Press each thumb on both sides of the upper corners and apply pressure downwards.
Then, while still applying pressure, slide the back cover down.

Vertaal

Stap 2

Remove the Battery.
Remove the SIM card.

Vertaal

Stap 3

Push the SD card in and the SD card should pop loose.
Pull the SD card out.

Vertaal

Stap 4

Remove the four 6-mm T5 torx screws in the four corners.
Remove the two 4-mm T5 torx screws in the middle.

Vertaal

Stap 5

Use the existing gap, to dislodge the antenna cover from the phone.
Pull out the antenna cover to have access to the motherboard.

Vertaal

Stap 6

Use a precision flathead screwdriver to dislodge the back plate from the phone by carefully inserting it into the slit between the frame and cover and pushing downward.
Go around the edges of the phone, and continue to dislodge the back plate from the front part of the phone.

Vertaal

Stap 7

Remove the 3-mm Phillips head screw located on the side of the bottom left-hand corner of the phone.
Remove the 3-mm Phillips head screw located on the top right-hand corner of the phone.
Do not remove any of the screws located on the actual circuit boards.

Vertaal

Stap 8

HTC myTouch 3G Motherboard Replacement: stap 8, afbeelding 3 van 3

Place a finger between the circuit board and the front cover, and lift up gently.
Continue separating the circuit board from the front cover and screen and watch for a ribbon cable to detach.
Finish separating the circuit board from the front panel.