Skip to main content

Inleiding

Before replacing your hard drive make sure you have backed up all of your files and have an OS install disk on hand. Now you're ready to replace your hard drive!

Onderdelen

Geen onderdelen opgegeven.

  1. Ensure your computer is shut down.
    • Ensure your computer is shut down.

    • Removing the battery while the laptop is still on may corrupt your files.

    • Remove any power adapters and cords connected to the laptop body.

    • Turn the computer over so the bottom is facing up.

    • These pictures show no battery, but your battery should still be in your computer at this point.

  2. The battery release is below the bottom right corner of the battery bay.
    • The battery release is below the bottom right corner of the battery bay.

    • Slide the switch to the right until the release clicks.

  3. Remove the battery.
    • Remove the battery.

    • The release switch may need to be held down while removing the battery.

  4. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  5. Remove the two 5mm Phillips screws on the hard drive cover using a Phillips #00 screwdriver. Remove the two 5mm Phillips screws on the hard drive cover using a Phillips #00 screwdriver.
    • Remove the two 5mm Phillips screws on the hard drive cover using a Phillips #00 screwdriver.

  6. Remove the plastic hard drive cover.
    • Remove the plastic hard drive cover.

  7. Pull up on the two plastic flaps on the hard drive enclosure to remove it. Pull up on the two plastic flaps on the hard drive enclosure to remove it.
    • Pull up on the two plastic flaps on the hard drive enclosure to remove it.

  8. Gently lift the ribbon cable away from the hard drive enclosure to free the drive. Gently lift the ribbon cable away from the hard drive enclosure to free the drive.
    • Gently lift the ribbon cable away from the hard drive enclosure to free the drive.

  9. Locate four 2mm Phillips screws on the side of the enclosure and remove them using a Phillips #00 screwdriver. Slide the hard drive out of the enclosure to complete the removal process.
    • Locate four 2mm Phillips screws on the side of the enclosure and remove them using a Phillips #00 screwdriver.

    • Slide the hard drive out of the enclosure to complete the removal process.

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Nick Loey

Lid sinds: 01-04-14

1.565 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 9-15, Regan Spring 2014 Lid van Cal Poly, Team 9-15, Regan Spring 2014

CPSU-REGAN-S14S9G15

4 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 13

Altijd: 1,236