1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic prying tool to remove the plastic frame surrounding the glass.

    Voeg opmerking toe

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    Voeg opmerking toe

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    Voeg opmerking toe

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    Voeg opmerking toe

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    Voeg opmerking toe

    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Voeg opmerking toe

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Voeg opmerking toe

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a Plastic Prying Tool to detach the white wiring connector from the circuit board.

    Voeg opmerking toe

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    Voeg opmerking toe

    • Pull the printer hood upward.

    Voeg opmerking toe

    • Lift the scanning lid from the lower portion of the printer hood.

    Remove torx screw on bottom of assembly in corner near touchsmart screen space.

    Jeff - Antwoord

    • Leaving the ribbon connected, lift the sliding scanner off the track.

    • Pull the ribbon cable out of the slot on the scanner circuit board.

    • Insert the scanning piece into the rolling track.

    Voeg opmerking toe

Conclusie

To reassemble the sliding scan piece, follow these instructions in reverse order.

Renee Lamb

Lid sinds: 26-09-12

226 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 2-11, Propen Fall 2012 Lid van Cal Poly, Team 2-11, Propen Fall 2012

CPSU-PROPEN-F12S2G11

4 Leden

6 handleidingen geschreven

Één commentaar

Where can i buy the scaning piece? Im from Spain.

Bogdan Cosmin - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 8

Altijd: 1,240