Ga door naar hoofdinhoud

Inleiding

The scanner is found underneath the scanner glass. If this piece stops moving, you will not be able to scan anything. It may need to be cleaned or replaced at this point.

Onderdelen

Geen onderdelen opgegeven.

  1. Open the top of the printer. The printer should appear as shown.
    • Open the top of the printer. The printer should appear as shown.

  2. Use the blue plastic opening tool to pry the trim pieces all the way around the printer. Loosen the pieces around the edges before pulling to remove from the printer.
    • Use the blue plastic opening tool to pry the trim pieces all the way around the printer.

    • Loosen the pieces around the edges before pulling to remove from the printer.

    • Pull the (4) trim pieces off and set them aside.

  3. Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels. The side trim pieces need to be removed before the front trim pieces.
    • Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.

    • The side trim pieces need to be removed before the front trim pieces.

  4. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  5. Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.
    • Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

  6. The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.
    • The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.

    • Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.

    • Both clips will come unattached and you can set the scanner flap aside.

  7. Lift the scanner glass piece from the printer and set it aside.
    • Lift the scanner glass piece from the printer and set it aside.

  8. Gently pick up the scanner piece as shown to see the bottom side and wiring. Gently pick up the scanner piece as shown to see the bottom side and wiring.
    • Gently pick up the scanner piece as shown to see the bottom side and wiring.

  9. Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece. Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece.
    • Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Charles

Lid sinds: 23-10-14

257 Reputatie

2 handleidingen geschreven

Team

Michigan Tech, Team 1-2, Lauer Fall 2014 Lid van Michigan Tech, Team 1-2, Lauer Fall 2014

MTU-LAUER-F14S1G2

3 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 6

Altijd: 589