Shut down the computer.
  • Shut down the computer.

  • Disconnect all external devices and cables from the computer.

Voeg opmerking toe

Flip the laptop over.
  • Flip the laptop over.

Voeg opmerking toe

Locate the gray sliding tab next to the black bar where the battery is located. Slide the gray sliding tab to the left until you hear a distinct click.
  • Locate the gray sliding tab next to the black bar where the battery is located.

  • Slide the gray sliding tab to the left until you hear a distinct click.

  • The inside edge of the battery should pop up.

Voeg opmerking toe

Grasp the inside edge of the battery. Lift the inside edge of the battery up to detach the battery from the laptop. Lift the inside edge of the battery up to detach the battery from the laptop.
  • Grasp the inside edge of the battery.

  • Lift the inside edge of the battery up to detach the battery from the laptop.

Voeg opmerking toe

Remove the highlighted screws.
  • Remove the highlighted screws.

  • After removing the screws, flip the laptop over.

Voeg opmerking toe

Open the laptop. Use the spudger to lift the keyboard.
  • Open the laptop.

  • Use the spudger to lift the keyboard.

  • Do not pull the keyboard up and away from the computer, because it is still attached by a ribbon cable.

  • Press the two white clips forward with your fingers and gently pull the ribbon from the clips.

Voeg opmerking toe

Turn the laptop upside-down again.
  • Turn the laptop upside-down again.

  • Remove the highlighted screws.

Voeg opmerking toe

Turn the laptop right-side up. Open the screen and tilt it all the way back. Locate the media keys.
  • Turn the laptop right-side up. Open the screen and tilt it all the way back.

  • Locate the media keys.

  • Gently lift up the media key strip using the plastic pry tool.

  • If there is too much resistance when prying, stop and search for cause of the resistance. Do not force the media keys.

Voeg opmerking toe

Remove the rubber inserts with the spudger.
  • Remove the rubber inserts with the spudger.

  • Note: When reassembling, notice that the two lower rubber pieces are flatter than the four rubber pieces located at the top of the screen.

  • Remove the screws behind the rubber inserts.

Voeg opmerking toe

Carefully pry loose the screen casing with a plastic prying tool. Carefully pry loose the screen casing with a plastic prying tool.
  • Carefully pry loose the screen casing with a plastic prying tool.

Voeg opmerking toe

Remove the plug by prying it loose with the spudger. Pulling the plug with your fingers could be potentially dangerous unless you are wearing work gloves.
  • Remove the plug by prying it loose with the spudger.

  • Pulling the plug with your fingers could be potentially dangerous unless you are wearing work gloves.

Voeg opmerking toe

Remove the single screw marked in the image.
  • Remove the single screw marked in the image.

  • Be careful not to break the clips or pull any wires.

Voeg opmerking toe

Remove the 4 screws marked in the picture. Support the back cover and set it down on the desk. Do not pull off the back cover. Support the back cover and set it down on the desk. Do not pull off the back cover.
  • Remove the 4 screws marked in the picture.

  • Support the back cover and set it down on the desk. Do not pull off the back cover.

Voeg opmerking toe

Remove the screws on each side of the screen. There are four screws on each side. Remove the screen.
  • Remove the screws on each side of the screen. There are four screws on each side.

  • Remove the screen.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Tyler Latour

Lid sinds: 12-03-14

236 Reputatie

3 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 6

Afgelopen 30 Dagen: 11

Altijd: 2,105