Onderdelen

Geen onderdelen nodig.

Remove one 9mm T10 Torx screw from the back of the printer lid.
  • Remove one 9mm T10 Torx screw from the back of the printer lid.

Voeg opmerking toe

Press outward on the plastic tab holding the back panel in place. Press outward on the plastic tab holding the back panel in place.
  • Press outward on the plastic tab holding the back panel in place.

Voeg opmerking toe

Pull the back panel towards you and lift it away from the rest of the printer cover. Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.
  • Pull the back panel towards you and lift it away from the rest of the printer cover.

  • Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Tim

Lid sinds: 15-01-13

134 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 18-35, Regan Winter 2013 Lid van Cal Poly, Team 18-35, Regan Winter 2013

CPSU-REGAN-W13S18G35

5 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 20

Altijd: 1,570