Inleiding

Without the scanner glass pane, your printer cannot complete two of its three major functions. Replace a broken one to keep your printer fully-functional.

Onderdelen

Geen onderdelen nodig.

Take all paper out of the paper tray. Unplug the printer.
  • Take all paper out of the paper tray. Unplug the printer.

  • Remove the plastic printer-control panel on the top left.

  • Then, forcefully lift up the bottom of the panel while applying downward pressure with your thumb-as shown.

Voeg opmerking toe

With your other hand, slide the top of the panel towards the back of the printer.
  • With your other hand, slide the top of the panel towards the back of the printer.

  • Do not rip the white cable that connects the panel with the main body of the printer.

  • Disconnect the ribbon by pinching the blue tab and pulling away from the green circuit board.

  • Lift the panel free and set to the side.

Voeg opmerking toe

  • Place the plastic opening tool between the plastic cover and the mount on the printer.

  • Pry the plastic cover towards the center of the printer.

  • Pull up on the cover to remove it from the printer-as shown.

  • Repeat the process on the other side.

Voeg opmerking toe

  • To remove the glass panel, take out the four 14 mm (1/2 inch) screws with a T10 Torx screwdriver.

  • Don't lift the glass panel completely off because there are cables plugged into the underside.

Voeg opmerking toe

  • Disconnect the white cables from the green motherboard by pinching the cable where it connects to the green motherboard. Pull up, lightly.

  • Set the lower part of the printer aside.

Voeg opmerking toe

  • Place the glass panel, face down, on a smooth surface.

  • Remove the 14 mm (1/2 in.) screw from the white plastic tab on the side of the panel with a T10 Torx screwdriver.

Voeg opmerking toe

  • Remove the glass pane by carefully bending the plastic frame down from the side and sliding the glass pane out from the side.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Samuel Isbell

Lid sinds: 09-10-12

10 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 9-18, Amido Fall 2012 Lid van Cal Poly, Team 9-18, Amido Fall 2012

CPSU-AMIDO-F12S9G18

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 12

Altijd: 2,740