Wat je nodig hebt
-
-
Orient the monitor screen down on a table. Be careful the work surface is not going to damage the screen when laying flat.
-
Remove the 4 12 mm screws from the base using a PH2 bit and driver.
-
Make sure to hold the screen at the bezel when the last stand screw is removed, gently lay the monitor flush with the table after the stand is removed.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
3 andere personen hebben deze handleiding voltooid.