Inleiding

This guide will help you replace your power module in a HP Color Laser Jet Pro MFP M277dw.

  1. Open and lower the back panel by pulling it down.
    • Open and lower the back panel by pulling it down.

    • Remove one Phillips #2 10 mm screw.

  2. Use the plastic opening tool to remove the right side panel of the printer.
    • Use the plastic opening tool to remove the right side panel of the printer.

    • Flipping the printer on its side, with the right side facing up, will make it easier to remove.

    • Remove two Phillips #2 12mm screws.

    • Remove four different pin connectors that attach to the power module located at the bottom.

    • Removing the white connector is made easier with assistance of a spudger/flat tip that loosens the clamp.

    • Remove two Phillips #2 10mm from the left (front) and right (back) side that attach the power module to the printer.

    • Slowly lift the power module from the printer using both hands.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Lyndon Fresnido

Lid sinds: 08-10-18

121 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team S4-G2, White Fall 2018 Lid van Cal Poly, Team S4-G2, White Fall 2018

CPSU-WHITE-F18S4G2

3 Leden

5 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 21

Altijd: 80