Skip to main content

Inleiding

This guide walks through the replacement of the HP Chromebook 11 G3’s touchpad. It will require the use of tweezers, a Phillips head screwdriver, and a spudger.

  1. Flip the laptop upside down so that the lid lies flat on the table. Remove the nine 6mm Phillips #00 screws that line the border.
    • Flip the laptop upside down so that the lid lies flat on the table.

    • Remove the nine 6mm Phillips #00 screws that line the border.

  2. Remove the two rubber feet closest to the hinge using tweezers. Remove the two 6mm Phillips #00 screws revealed under these rubber feet.
    • Remove the two rubber feet closest to the hinge using tweezers.

    • Remove the two 6mm Phillips #00 screws revealed under these rubber feet.

    • The rubber feet may tear while removal; preventing this can be difficult, but it won’t harm the laptop. If desired, replace these rubber feet during reassembly.

  3. Flip the laptop so it is in the upright position.
    • Flip the laptop so it is in the upright position.

    • Open the lid.

    • Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.

    • This may require more force than expected. Hearing loud clicks as the plastic opening tool slides along the seam is normal.

  4. Android Fix Kits

    Slechts één reparatie scheidt jou van een nieuw scherm of een nieuwe batterij.

    Nu winkelen

    Android Fix Kits

    Slechts één reparatie scheidt jou van een nieuw scherm of een nieuwe batterij.

    Nu winkelen
  5. Tilt the keyboard mount up. Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard. Gently remove both ribbon cables.
    • Tilt the keyboard mount up.

    • Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.

    • Gently remove both ribbon cables.

  6. Lift the keyboard mount out of the laptop.
    • Lift the keyboard mount out of the laptop.

  7. Flip the keyboard mount upside down. Use tweezers to lift the tape on the bottom of the touchpad to expose the connector. With a spudger, push up the ZIF retaining flip.
    • Flip the keyboard mount upside down.

    • Use tweezers to lift the tape on the bottom of the touchpad to expose the connector.

    • With a spudger, push up the ZIF retaining flip.

    • Pull out the small ribbon cable.

  8. Remove the two Phillips #00 2mm screws that secure the touchpad to the black plastic housing. Flip the keyboard mount to the upright position.
    • Remove the two Phillips #00 2mm screws that secure the touchpad to the black plastic housing.

    • Flip the keyboard mount to the upright position.

    • From beneath, push the touchpad up through the top of the keyboard mount to remove it.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Rahul Goyal

Lid sinds: 26-04-17

1.337 Reputatie

10 handleidingen geschreven

Team

Cal Poly, Team S23-G3, Livingston Spring 2017 Lid van Cal Poly, Team S23-G3, Livingston Spring 2017

CPSU-LIVINGSTON-S17S23G3

4 Leden

12 handleidingen geschreven

Voeg een opmerking toe

Bekijk statistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 14

Aller tijden: 489